2
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
FLR10P/FLR20P/FLR30P/FLR50P
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• Installation of this luminaire should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this load is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this product when deciding the location for
installation
• This product series is IP65 rated
• This product is Class I and must be earthed
• This product is non-dimmable
• Outdoor electrical installations should be protected by an earth leakage circuit breaker such as a
residual current device (RCD). This will cut the power supply should it detect a leakage of current
to earth which is potentiality dangerous
• Provide power to the required point of installation
• This product has an angled bracket for ease of
installation and does not need to be removed
(see Fig 1)
Fig 2
Fig 1
FLRXX
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following products:
FLR10/ FLR20/FLR30/FLR50 Floodlight series
SAFETY
•
Installation of this driver should only be carried out by a qualified electrician or competent person to the
latest Building and current IEE Wiring Regulations (BS7671)
•
Please isolate mains prior to installation/maintenance
•
Check the total load on the circuit (including when this load is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress of Protection) rating of this product when deciding the location for installation
•
This product series is IP65 rated
•
This product is Class I and must be earthed
•
This product is non-dimmable
INSTALLATION
•
Provide power to the required point of installation
•
Using the angled bracket as a template, mark the location of the fixing holes and drill the holes ensuring not to
infringe with any gas/water pipes or electrical cables
•
Remove the four screws on the access plate at the rear of the fitting to expose the terminal block (see Fig 1)
Screws
Fig 1
•
Feed the cable through the compression gland on the rear of the access plate. Ensuring correct polarity is
observed, carefully wire as shown in Fig 2
Fig 2
•
Replace the access plate, gasket and screws then tighten the compression gland ensuring a tight seal to maintain
the IP rating
•
Switch on power supply and check for correct operation
• Using the angled bracket as a template, mark
the location of the fixing holes, and drill the holes
ensuring not to infringe with any gas/water pipes
or electrical cables
• Remove the four screws on the access plate at the
rear of the fitting to expose the terminal block
(see Fig 2)
