Knightsbridge DC006, Installation & Maintenance Manual

Page: 4 / 7

FUNCTIONS GUIDE
Chime operation
Press the push button on the sensor unit once, a wireless signal is sent to the receiver which will
sound. The sound will stop as soon as the melody ends.
Melody selection
The melody selector is located on the back of the door chime on the right. Press the selector to
choose a different melody, then activate sensor once to store.
Sound and Flash
The Sound and Flash switch is located on the back of the receiver on the left. Slide the switch to the
left position, the receiver will work with sound only; slide to the middle position, the LED will flash
only; slide to the right position, there will be sound and LED flash.
Volume adjustment
The volume button is located between the melody selector and the sound and flash switch. Press to
adjust the sound volume - high, medium, or low.
Auto-learning code button
There is an auto-learning code button under the melody selector. If you want an additional sensor to
work with the receiver, press the auto-learning code button once and the sensor will work with the
receiver.
SPECIFICATION
PIR sensor
Power: 3 x AAA 1.5V batteries (not included)
PIR angle: 100° (wall mounted)
PIR range: <5m (dependent on environment)
Transmission range: 80m (dependent on environment)
Receiver
Receiver
Remove the battery cover and insert 2 x AA 1.5V batteries (not included). Ensure battery polarity
matches the internal markings.
Mounting PIR sensor
• Mark the location of the fixing holes, and drill the holes ensuring not to infringe with any gas
/ water pipes or electrical cables
• Drill 2 holes on the wall at the required height and Insert wall plugs
•
Place the mounting bracket over the holes
• Insert the screws into the wall plugs (not included)
• Install the sensor