2
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following products:
24DCIP60 / 24DCIP100
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• Installation of this driver should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this driver and LED load is fitted) does not
exceed the rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this product when deciding the location for
installation
• This unit is rated at IP67
• This product is Class I and must be earthed
• This product is non-dimmable
• Provide power to the required point of installation
• Connect the LED driver to the mains supply ensuring the correct polarity is observed (see Fig 1)
Live (brown), Neutral (blue) Earth (green/yellow)
• Connect a suitable LED load to the secondary side of the (red) – (black)
• Switch on power supply and check for correct operation
LED Drivers
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following products:
12DCIP60 / 24DCIP60
SAFETY
•
Installation of this driver should only be carried out by a qualified electrician or competent person to the
latest Building and current IEE Wiring Regulations (BS7671)
•
Please isolate mains prior to installation/maintenance
•
Check the total load on the circuit (including when this driver and LED load is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress of Protection) rating of this product when deciding the location for installation
•
This unit is rated at IP67
•
This product is Class I and must be earthed
•
This product is non-dimmable
INSTALLATION
•
Provide power to the required point of installation
•
Connect the LED driver to the mains supply ensuring the correct polarity is observed (see Fig 1). Live (brown),
Neutral (blue) Earth (green/yellow)
Fig 1
•
Connect a suitable LED load to the secondary side of the (red) – (black)
•
Switch on power supply and check for correct operation
WARNING
This product must be disconnected from the circuit if it subjected to any high voltage or insulation resistance testing.
Irreparable damage will occur if this instruction is not followed.
GENERAL
The unit should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where
facilities exist.
Fig 1
