Page 2
Assembly Instructions
knightgroup.co.nz
Step 1
Step 2
Step 4
Page 2
Assembly Instructions
Step 3
Ensure the frame is located in the centre of the
worksurface. Fully tighten all 6 screws on each
mechanism.
On all tables with width larger than 700mm, secure
the pull bar with the supplied washer and screw in
the location pictured below (slot end closest to the
pull-bar). Leave screw 1 turn from tight so the pull-
bar can be operated smoothly.
Fit the pull bar to the top side of the mechanism
according to the number corresponding to your
worksurface depth. This number will locate over of
the raised cylinder.
Place the pull bar
(a) and cross tube (b) in the cor-
rect location pictured below, slide the 2 end legs in
place, and tighten 2 small screws into the cross tube.
Team Flip
(b)
(a)
