Page 34 of 40
0901034 Rev: REL (09/13)
Downloading/Viewing Reports
Check that the USB drive you will use is properly formatted for use with this system. If the drive is not properly
formatted you cannot save report files from the system or properly upload settings. The following procedure will help
you do that:
Load drive into pc USB port
a. Go to My Computer
b. Right click USB drive
c. Check File System setting for FAT32
d. If it’s FAT (default) click down arrow and select FAT32
e. Click Start to reformat
f.
Remove USB flash drive
g. Ready for use
Select the USB flash drive in the Select Drive pull-down. Select the file to copy then click on the Copy button. Repeat
for any other setup files.
After setup files have been uploaded from the USB drive access the programming menus on the system and check
that your settings have transferred properly. Once the settings are in place proceed to calibrating the pumps before
starting operation.