Knick P 27000 H1-S011, Manual

Page: 15 / 24

15
2. Intended Use
The special models of the series P 27000-S011 are used for galvanic isolation
and conversion of input signals from 0 ... ±282.85 V to output signals from
±0 ... 10 V. Signal transmission is linear. The broad-range power supply allows
operating the devices with voltages from 20 to 253 V AC/DC.
Connection is made using pluggable screw clamp terminals.
Warning against misuse
Do not operate the device outside the conditions specified by
the manufacturer, as this might result in hazards to operators or
malfunction of the equipment.
3. Configuration
3.1 Tools
A screwdriver with a width of 2.5 mm is required to open the unit and to
connect the wires to the screw clamp terminals.