Knick 830 R, Manual

Page: 84 / 216

E-84
Installing the Indicator
The following is required for installing the
indicator:
• 1 screwdriver with 3.5 mm blade
Proceed as follows:
Type S1
• Pull the two slide retainers out of the
groove. (To do so, bend the protruding
tab outwards.)
• Push the indicator from the front into
the panel cutout.
• Make sure that the gasket is securely in
place.
• Push the two slide retainers into the
groove until the rest position is reached.
• Tighten the indicator using the screw
spindles.
Type S2 • Push the indicator from the front into
the panel cutout.
• Make sure that the gasket is securely in
place.
• Pull out the two locking bars.
Loosen the knurled screw if required.
• Tighten the indicator using the knurled
screws.