K'Nex COLLECT & BUILD FERRIS WHEEL, Manual

Page: 2 / 16

IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these instructions in a handy
location. They contain important
safety information.
Read all warnings and instructions
before you start to build and
operate the model.
WARNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
CAUTION: Be careful not to tip the model
over. Model should be placed on a flat and hard
surface.
• Share the K'NEX experience with your child
and make building with K'NEX a family fun
adventure.
• Take your time to enjoy the building process.
Don't rush!
• While you’re building make sure you face your
model in the same direction as the pictures
show in the instructions.
• Be sure to install batteries into the motor before
you start building your motorized models.
• Product and colors may vary.
!
BATTERY INFORMATION
Caution: To Avoid Battery Leakage
• Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions.
• Do not mix old and new batteries or alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium) batteries. Only batteries
of the same or equivalent type recommended should be used.
• Always remove weak or dead batteries from the product; do not
short-circuit supply terminals.
• Insert batteries with correct polarity (+/-) as shown.
Important Tips:
• Alkaline batteries AA (LR6) are recommended.
• Rechargeable batteries are not recommended.
• Remove rechargeable batteries from toy before charging; they
must be charged only under adult supervision.
• Non-rechargeable batteries must not be recharged.
• Keep components free of dust; do not immerse or use in water.
• Do not dispose of batteries in a fire; they could leak
or explode and cause injury.
• Remove all batteries if the toy will not be used for a long period of time.
• Do not put Rods smaller than 2 inches in any openings of the
motor; they will damage the motor, and cannot be removed.
How to Insert and
Remove Batteries:
• Use a small Phillips head
screwdriver to loosen the
screw. Insert 2 fresh AA
batteries (LR6) into the
compartment with the
correct polarity (+/-) as
shown here.
+
-