24
Installation and initial startup
BlueShadow Detector 40D Instructions V7647
4.8 Analog control
Analog ports serve for exchanging analog control signals .
Reference point for the signals is the connector „ground“ GND .
OUT: Device sends signal .
IN: Device receives signal .
4.9 Integrator Port
The integrator connector sends measuring signals from the detector .
Non-bipolar
1 channel
0 to 5 V
DAC 20 bit
Scalable
Adjustable to offset
4.10 Switching on
The device is switched on by the power key on the back of the device .
Installation has been completed .
Flow cell is mounted on the detector .
Process
Figure
1.
Insert the plug into the male
connector
2
at the rear
panel .
2.
Plug the other end into an
electric socket .
3.
Switch on the device at the
power switch
1
.
Fig. 12
Power switch with male
connector
Prerequisite
Procedure
1
2
