AZURA® Valve Unifier VU 4.1 Instructions V6855
Unpacking and setup 11
4.
Clasp the device from below, lift it out of the packaging and place it
on its feet. Do not hold onto the front cover.
5.
Check the device for signs of damage that occurred during transport.
In case you notice any damage, contact the Technical Support.
6.
Place the device in its site of operation and remove protective foil.
Store packaging and keep the included packing list for repeat orders.
6.3
Power supply
Use only the enclosed power cable to connect the device to the power
supply to make sure that the specifications stated in Technical Data are
met. But check beforehand to use power cables which are admitted for
use in your country. Replace defective power cables only with accessories
from KNAUER. Do not replace detachable power cables with different
cable types.
Electronic defect
Electronic hazard when using an identically constructed power adapter
from another manufacturer.
Î
Only use spare parts and accessories from KNAUER or a company
authorized by KNAUER.
The electrical power supply at the installation site must be connected
directly to the nearest main power line.
The power must be free from ripple, residual current, voltage peaks
and electromagnetic interference.
The connectors for the mains voltage are grounded accordingly.
The device receives sufficient power with reserve capacity
The device is intended for use with AC power networks of 100 – 240 V.
Make sure that the power plug on the power supply (wall mounted
socket or power strip) is always accessible, so that the device can be
disconnected from the power supply.
Next steps
Prerequisites
Power Plug
