28
Operation
AZURA® Detector UVD 2.1S Instructions, V6820
5.4.2 Choosing a control option
Choose between analog or digital ports to control the device accordingly.
LAN DHCP: Control with LAN, IP address is obtained automatically
(recommended)
LAN MANL: Control with LAN via a static IP address
RS-232 9600: Serial port for cables longer than 2 m
RS-232 115200: Serial port for cables with up to 2 m length
ANALOG: Wavelength selection via applied voltage
Where applicable: a physical connection has been established.
Status display is active.
Process
Figure
1.
Keep left arrow key pressed. Scroll using
the right arrow key until the correct dis-
play appears.
Fig. 14
Control option
2.
Let go of left arrow key.
3.
Using both arrow keys, choose a port.
When setting is finished, the status display appears.
5.4.3 Checking or editing LAN settings
The current IP address, subnet mask, gateway and port settings of your
device can be checked via the main menu. This is possible for LAN DHCP
and LAN MANL control options. For LAN MANL it is furthermore possible
to edit your LAN settings. The following representations are used in the
LAN menu:
IP Addr1
192
NetMask1
255
Def.GW 1
192
IP Port
10001
IP address
Subnet mask
Gateway
IP port
Where applicable: a physical connection has been established.
Status display is active.
Note:
Each number 1–4 in IP address, subnet mask and gateway stands
for 3 digits, e. g. 1 stands for the first 3 digits, 2 for the next 3 digits, etc.
Process
Figure
1.
Select your desired control option (see
Fig. 15
Example for
control option
2.
Press autozero to enter into the LAN
menu.
Prerequisite
Procedure
Control
LAN DHCP
Result
Prerequisite
Procedure
Control
LAN DHCP
o
AZ
