With a pencil, make a mark 1-3/8" back from the front outside edge of the cabinet. Place the sliding drawer
assembly with the front edge of the front mounting strap directly behind this line. With a pencil, mark the cabinet
floor through the front two mounting hole locations. Remove the drawer from the cabinet. With 1/16" drill bit,
drill pilot holes through the two mounting hole locations you marked.
Pull the wood cabinet drawer completely forward. Place the entire assembly back inside of the cabinet so
that the front mounting holes line directly over the pilot holes you drilled in the cabinet floor. Fasten the front
mounting strap to the cabinet floor using two mounting screws.
Now that the front mounting strap is mounted to the cabinet floor drill pilot holes in through the rear mounting
hole locations with the 1/16" drill bit. Fasten the rear mounting strap to the cabinet floor using two mounting
screws. Push the wood cabinet drawer all the way back into the cabinet. Installation is now complete.
Parts Included
A. Sliding Drawer Assembly
B. Mounting Screws (4)
Soft-Closing Wood Cabinet Drawer
Installation Instructions
310315-B-1213
Inspect all parts and read all instructions prior to beginning assembly and installation.
2
1
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
©2013 Knape & Vogt. All rights reserved.
Knape & Vogt
®
reserves the right to change specifications without notice. Made in USA.
A
3
2
1
3
Product Assemblies
WMUB-11-4-R-ASP
WMUB-14-4-R-ASP
WMUB-17-4-R-ASP
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16˝ (1.5mm) bit for drilling
pilot holes
• Pencil
B
1-3/8"
(3.5 cm)
