4 I English
3551
1
TECHNICAL DATA
Type
3551
Dimensions mm
260/284
Weight kg (without fasteners)
1,9 kg
Single sequential or contact actuation
Recommended operating pressure
range
5 - 7 bar/
0.5 - 0.7 MPa
Maximun permissible operating
pressure
7 bar/0.7 MPa
Air consumption per driving
operation
0.7 l at 7
bar / 0.6 MPa
Magazine capacity.
No. of fasteners
250-300
Penetration depth setting
yes
Fasteners: wire bound nail coils
Nail length mm
25-50
Nail shank Ø mm
1.6-2.1
Recommended lubricant
1 litre special oil. Code no.
9 4420
250 cm3 grasa especial. Code no.
68 3868
2 NOISE / VIBRATION INFORMATION
Noise characteristic values *
3551
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
85.8 dB(A)
A-weighted sound power level
L WA, 1s, d
93.7 dB(A)
Vibration characteristic values **
Weighted r.m.s.-acceleration (a),
a h, w, 3s
3.4 m/s2
The noise level when working can exceed 85 db
(A). Wear ear protection!
*
Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3
SUPPLIED WITH
1 Coil nailer
1 Tool use and safety instructions
1 Technical data sheet
4 FILLING THE MAGAZINE
When filling the magazine, hold the tool so that the
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety yoke
or trigger depressed.
First, remove the rubber band from the nail coil.
To open the magazine, unlock the guide flap (k). Hold
the nailer in such a way that the magazine is completely
open and in a horizontal position.
Pull and turn the nail support (n) to set the required
nail length according to the scale.
The beginning of the coil has to project into the nail
channel.
The nail coil has to be able to move freely.
Close the magazine cover again.
5
SWITCHABLE ACTUATION, FIG. 2
-SINGLE TRIGGER RELEASE / RELEASE ON CONTACT-
A setting wheel on the
trigger (s) can be turned
to set the type of actuation
either to single trigger
release or release on
contact (see symbol).
6
FIL PENETRATION DEPTH SETTING, FIG. 1
The penetration depth of
the nail head is adjusted
using air pressure. Should
this not suffice, a more
exact setting of the
penetration depth can be
achieved by turning the
setting nut (p).
Right-hand turn (U) = less
penetration depth.
Left-hand turn (D) = more
penetration depth.
7
ACCESSORIES
Code no.
Balancer for 20-30 N (2.0-3.0 kp),
cable travel 2.0 m.
40 3407
s
p
D
U
Only those fasteners specified under technical data
(see 1) may be used.
KMR
