EN - 7
Device-specific additional instructions for nailer
...3725
4
Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position
(Chap. 3): The driving nose must point away from any
person. It must be impossible to unintendly actuate trigger
and/or release protection.
•
Insert nail strip into the magazine from the rear and push
forward. Pull pusher 1 backwards behind the nail and push it
forward again.
5
Hole finding in the wood connector
•
Position the tip of the tool in the hole of the wood
connector. Press down and trigger the tool.
6
EU Declaration of conformity
The Joh.
Friedrich
Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
-------------------------------------------------
-----------------------------------------------------------
Tobias Fischer-Zernin, Management
Joachim Bauer, Documentation responsible
Summary of Contents for 12100565
Page 3: ...3 ...
