19
Grease all pivot joints every 8-10 hours of use, or every 125-130 acres, whichever comes first.
Annually: Check gauge wheel hubs for grease and pack if necessary.
LUBRICATION
MAINTENANCE PROCEDURES
STORAGE
Coat all exposed cylinder rods with grease. If cylinder rods are left extended and unprotected,
rust may build up on rods & cause seal problems.
SPECIAL CONSIDERATIONS
The machine should be lifted when making sharp turns.
Do not backup with machine in the ground.
After the first few hours of operation, check all bolts to make sure they are still tight.
The optional 1 3/4" HD tine is required for depths greater than 4" or in severe
conditions. Bending standard tines by operating them in severe conditions is not
covered under warranty.
3 Grease Zerks
1 Grease Zerk
1 Grease Zerk
3 Grease Zerks
24 Grease Zerks
(Front and rear pivot of reach arms)
8 Grease Zerks
(1 per wheel, rear of hub)
