4
•
The appliance must stand on a level surface and must not touch the wall. If
necessary, regulate the height of the appliance by adjusting the levelling feet: by
turning them clockwise – the front of the appliance rises, by turning them counter
clockwise – it comes down. If the appliance is tilted slightly backward – the doors will
close by themselves.
Preparing for operation:
•
It is recommended to prepare the appliance for operation with a helper.
•
Remove package. Lift the appliance away from foamed polystyrene base. Tear off
adhesive tapes.
•
When positioning the appliance in chosen location, it will move more easily into position if
you lift the front a little and incline it backward, allowing it to roll on its casters.
When
placing, moving, lifting the appliance, do not hold the door handles, do not pull
the condenser at the rear part of the refrigerator and do not touch the
compressor unit.
•
Remove all red-coloured parts from the
shelves (fig. 2.). Tear away the red-coloured
adhesive tapes from the door trays – they are
intended only for the transport of the
appliance.
NOTE. When you open the freezer compartment door
a little red packing detail will fall out – IT IS FOR
TRANSPORTATION PURPOSES ONLY.
•
Take two supports
1
from the bag and insert
them into the guides
2
at the top back part of the
appliance (see picture).
The appliance
should not be connected
to the mains until all packing and
transport materials aren’t removed. Suitably dispose the packaging material.
First use:
•
Before using the appliance for the first time, the interior and all internal accessories
should be washed with lukewarm water and some neutral soap to remove the typical
smell of a brandnew product, then dried thoroughly.
Wait at least 4 hours before connecting the appliance to the
power supply
. This is to allow the oil to flow back in the compressor.
•
When first starting-up or after a period out of use, before putting the products in the
compartment let the appliance run at least 2 hours.
