58
Connecting the receiver unit to the power supply
1 Receiver unit
4 Plug-in connection receiver unit – camera module
2 Monitor connection (HDMI)
5 Support
3 Power supply connection
6 Handle – camera assembly
•
Support the handle – camera assembly (6) with an approx. 40 mm-high block (5) to provide strain relief
for the plug-in connection.
•
Connect the male D-Sub connector on cable (4) of the handle – camera assembly (6) to the 25-pin built-
in female D-Sub connector of the receiver unit (1).
•
Wait until the green
Power
LED flashes only briefly, with longer interruptions.
–
The receiver unit is in operating mode and supplies the camera module with power.
Starting pairing
•
Press the
Pairing
(3, Fig. 7-2) button on the receiver unit.
–
When the
Pairing
LED is lit red, the connection has been established (successful pairing).
If this is not the case, please see “Connection process failed”, page 58.
–
When the yellow
Status
LED is lit with short interruptions, the handle – camera assembly can be
installed in the light.
•
Disconnect the handle – camera assembly from the pairing connection and install it in the light.
–
When the camera is supplied with power again, the wireless connection between the handle –
camera assembly and the receiver unit is established automatically.
–
The camera signal is shown on the monitor.
Connection process failed
Rapid flashing of the green
Power
LED indicates a failed connection!
•
In this case, check the monitor connection and the power supply for the receiver unit.
•
Restart the Pairing.
•
Please contact the Martin Service Center if the connection cannot be successfully established after 2–3 attempts.
