User's Manual
‘SP’ Models based upon the CA Series
KLING & FREITAG GMBH ©2003 - 2006
Version 6.1, 19.06.2006
Page 32 of 54
13.5
CA 1515-6 - SP
Loudspeaker
Design
2-way full-range system with integrated driver
and power amplifier technology, bass reflex tuning
Frequency range -10 dB
47 Hz - 22 kHz ('FILTERS OFF')
Frequency range
±
3 dB
77 Hz - 19 kHz ('FILTERS ON' and 'FILTERS OFF')
Nominal coverage angle
65°x 50° (hor. x vert.) / rotatable horn
Directivity index (DI)
12 (+1.5/-2) 1.2 kHz -16 kHz
Max. SPL
130 dB (SPL peak/1 m)
Components
15" low-mid chassis
1.5‘‘ high freq. driver with 75 mm titanium dome
on rotatable 65°x 50° CD horn
Crossover
passive, 1.1 kHz 12 dB/octave, self-resetting protection
circuits for 1.5" chassis, time and phase correction
delay time and phase alignment
Supply
voltage
230 V version: AC 195-250 V, 50 / 60 Hz
alternative
115 V version: AC 95-125 V, 50 / 60 Hz
Power
consumption
nominal
@ 230 V: 1.25 A
@ 115 V: 2.5 A
Power consumpt. max (Irms / <500 ms)
@ 230 V: 7 A
@ 115 V: 14 A
Idle
current
@ 230 V: 200mA
@ 115 V: 400 mA
Power
connectors
Neutrik PowerCon, lockable, 1 input and 1 output
Input module
Signal
connectors
Pin 1 = ground / pin 2 = + signal / pin 3 = - signal
LINE IN: XLR 3 pin female
LINE OUT: XLR 3 pin male, parallel with LINE IN
Input
sensitivity
+6 dB / 1.55 Vrms for rated output
Input
impedance
50 k
Ω
(balanced / unbalanced)
Common
mode
rejection
Min.: 74 dB, typical: 90 dB
Controls
Level control ± 6 dB, by-pass switch for the
active filters (for operations with i.e. K&F Controller C2),
ground lift switch
Display
Bi-coloured LED: green = Power On,
red = Limit / Protect
Driver
circuit
High pass 45 Hz (-3 dB), 24 dB / octave (‘FILTERS ON’),
Phase correction, frequency equalisation (EQ)
peak limiter, RMS limiter
Amplifier module
Type
Class D
Power
1000 W @ 8
Ω
( EIAJ / 1 kHz, 1% THD)
Power
bandwidth
10 Hz to 30 kHz
Damping
factor
> 500 (100 Hz), > 100 (10 kHz)
S / N ratio
> 105 dB (A)
Cooling
Air convection (without fan)
Protection
circuits
Short circuit, over-temperature, clipping, overload
Enclosure
Trapezoidal with monitor and cluster angles,
15 mm birch plywood with highly resistant
grey or black structured paint,
2 butterfly handles, mounting flange K&M 19656,
ball proof front grille with exchangeable,
black acoustic foam
Rigging
5 flying points ‘allsafe JUNGFALK’
Dimensions
433 x 680 x 410 mm (W x H x D)
Weight
38.9 kg
Options
Rigging and mounting hardware,
special finish in RAL colours
Technical changes without prior notice reserved
