Klimor EVO-RX, Operation And Maintenance Manual

Page: 37 / 82

35
4.1.1 Transport handles
Each section of the control panel is equipped with
transport handles designed for lifting the sections with
a crane. The transport handles must be removed imme-
diately after installing the section for which they are
intended. Attempting to install the external section
without removing the transport handles from the in-
side section can cause serious damage to the unit’s
construction. Damage resulting from attempted im-
proper installation is not covered by the manufacturer’s
warranty.
Fig. 6 Position of the transport handles in the outdoor unit
TYLKO NA CZAS TRANSPORTU
Fig. 7 Position of the transport handles in the indoor unit
4.2 Assembly and installation of the units
4.2.1 Roof vent base
The roof vent base should be made as a reinforced con-
crete or steel structure, taking into account the
strength requirements adapted to the weight of the
unit specified in the selection sheet according to di-
mensions
For the top surface of the roof base, a flatness tolerance of
4 mm and a maximum deviation of 1 mm/m is required.
There should be a conduit for power and control wir-
ing near the base.
To ensure proper operation of the func-
tional elements and to maintain the tight-
ness of the construction, the units should
be placed on a level ground.
Table 4 Base dimensions
SIZE
BASE DIMENSIONS
□
A
□
A1
[MM]
EVO-RX 0500 1030 1230
EVO-RX 0800 1130 1330
A1 A1
A A
min. 200min. 200
max. 500max. 500
55
Fig. 8 Base dimensions
Only for the transport