kliksystems.com.au · [email protected] · [email protected] · t: +612 9851 3300
32865-B
www.kliksystems.com.au - [email protected]
60mm
Match colours of wires as shown in the images below.
Insert wires into connectors as far as possible and push down blue tabs to splice the wires.
IMPORTANT :
ONLY
connect 24V DC supply input to the
Blue
and
Red
Soft starter
DO NOT connect power to any other wires.
Blue IN
Negative [-]
Red IN
Positive [+]
Black OUT
Negative [-]
Red OUT
Positive [+]
2
3
5
4
24V DC IN Black
Negative [-]
24V DC IN Red
Positive [+]
LEDPOD OUT
Black Negative [-]
LEDPOD OUT
Red Positive [+]
Cut wires at the centre
of the loop.
24VDC Supply
INPUT
To LEDPods
OUTPUT
Carefully feed one
connector at a time
through the
LEDPOD holes.
Carefully pull out a
loop of wire at the
first LEDPOD location.
Feed power wires
through tubing
Soft starter complete
with pre-fitted connectors
1
To 24V DC Supply
INPUT
To LEDPODs
OUTPUT
Move components down to make room for retaining clasp insertion.
Refer to page 1 for LEDPOD installation instructions.
6
R
LEDPOD Soft Start Relay Installation Instructions
(Use for 350mA drivers only)
PAGE 2 OF 2
32863-C
