191
IMPORTANT
: Use this function cautiously. In some cases more than one break can occur on a closed path.
•
The
Close Path
function can be applied to any open shape, other than a straight line, to join the start and
ending nodes with a straight line:
•
To apply
Close Path,
select an open shape and use either of the following:
Go to
Path>Close Path
Right-click and select
Path>Close Path
•
The path will then fill with whatever
Fill
property is currently assigned to that shape.
•
Join Paths
will connect two nodes from two different open paths if those nodes are in very close proximity
to one another.
•
To access
Join Paths
, select the two open shapes and go to
Path>Join Paths
:
•
If you are joining several lines at once, such as these four lines to create a box, then all four lines can be
selected at one time and be joined. However, for the new shape to be an actual closed shape, you must
then apply
Path>Close Path
:
Left side will cut dashed
Left side will be scored separately
Left side won’t cut at all
Two individual lines
Move one line to just
touch the other
Apply
Path>Join Paths
Four individual lines
Select all 4 and apply
Path>Join Paths
Apply
Path>Close Path
Summary of Contents for KNK Force
Page 306: ...306...
