Kleinn Air Horns CANX3-KIT, Installation Manual

Page: 32 / 44

CANX3-KIT
Installation and Operation Manual
Go to Table of Contents PG 32/44 REV: A (9/4/2020)
8.10. Air Compressor - Installation
8.10.1. Route 1/4” Air Tubing, which is connected to front of Air Tank from bench assembly step ( Figure 13 )
across back of firewall, or above chassis, as desired. There should be at least 12 inches of excess tubing
sticking out of
Driver’s side to manipulate and connect to Air Compressor . Once route is selected,
secure Air Tubing in place.
WARNING : Route plastic tubing distant from heat sources; tubing should never exceed 150 deg F while
in use, as tubing can rupture under 150 psi compressed air and cause harm, or injury.
Figure 24 – Air Tubing Route from Air Compressor to Air Tank
Route Air Tubing
across Firewall, or
above Chassis