Gas adjustment
1
2
Injector
Control handle
Tap
Sealing ring
23
Remove the pan support, burner cap and burner head.
Unscrew the injector using a 7mm box spanner and
replace it with the stipulated injector for new gas supply.
Carefully reassemble all components.
After the injectors are replaced, it is advisable to tighten
the
m firmly
in place.
Adjustment of minimum level of the flame.
Turn the taps down to minimum
.
Remove the knob from the tap and place a small
bladed screwdriver in the centre of the tap shaft.
The correct adjustment is obtained when the flame
has a length of about 3 - 4 mm.
- For butane / propane gas, the adjusting screw must
Make
sure that the flame does not go out by
quickly
turning
from maximum flow to minimum
flow. If it does then remove the control knob and
make further adjustments to the gas flow, testing it
again once the
adjustment has been made.
Repeat this process for each one of the gas taps.
be tightly screwed in.
Refit the control knob.
Ŷ7DNHSUHFDXWLRQVRQWKHRSHUDWLRQVDQGDGMXVWPHQWVWREHFDUULHGRXWZKHQ
FRQYHUWLQJIURPRQHJDVWRDQRWKHU
Ŷ$OOZRUNPXVWEHFDUULHGRXWE\DTXDOL¿HGWHFKQLFLDQ
Ŷ%HIRUH\RXEHJLQWXUQRIIWKHJDVDQGHOHFWULFLW\VXSSO\WRWKHDSSOLDQFH
-
Ŷ%HIRUHSODFLQJWKHEXUQHUV
EDFNRQWKHWRSSOD
t
HPDNHVXUH
WKDWWKHLQMHFWRULV QRWEORFNHG
DTXDOL¿HGWHFKQLFLDQRULQVWDOOHU
must
PDUN³9´RQWKHULJKWJDV
FDWHJRU\
WRPDWFKZLWKWKH
VHWWLQJ
o
Q
the r
DWLQJSODWH
5HPRYHWKH³9´PDUN
from the
previous setting
LQWKHHYHQWRIDPDOIXQFWLRQ
FKDQJHWKHZKROHWDS
Ŷ$IXOORSHUDWLRQDOWHVWDQGDWHVW
Ŷ$IWHUFRPSOHWLQJFRQYHUVLRQ
IRUSRVVLEOHOHDNDJHVPXVWEH
FDUULHGRXWDIWHU
gas conversion
VXFKDVVRDSZDWHURUJDV
GHWHFWRU
.
Change the injector of the burners.
Ŷ
Do not dismantle the tap shaf
t
:
