33
OVEN
The oven with smooth enamel must be cleaned after every use, using suitable prod-
ucts. Please note that after using the oven for 30 minutes on the highest temperature
eliminates most grime reducing it to ashes.
Do not use abrasive substances to clean the oven.
INSIDE OF OVEN
This must be cleaned regularly.
Remove and refit the side runner frames as described on the next chapter.
With the oven warm, wipe the inside walls with a cloth soaked in very hot soapy
water or another suitable product.
Side runner frames, tray and rack can be removed and washed.
GREASE FILTER
Clean the filter after any cooking! The grease filter can be removed for cleaning
and should be washed regularly in hot soapy water (fig. 12).
Always dry the filter properly before fitting it back into the oven.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the oven is cool unscrew and replace the bulb with another one resistant to
high temperatures (300°C), voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not covered by your guarantee.
ADVICE FOR USE AND MAINTENANCE OF CATALYTIC
PANELS
The catalytic panels are covered with special microporous enamel which absorbs and
does away with oil and fat splashes during normal baking over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven “idling” on
max temperature for about 30 minutes. These panels do not require to be cleaned,
however it is advised to periodically remove them from the oven (at least the side pan-
els) and to wash them with tepid soapy water and then wipe off with a soft cloth.
DO NOT CLEAN OR WASH THEM WITH ABRASIVE PRODUCTS OR WITH
PRODUCTS CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when the catalytic microporous enamel degrades,
they can be turned to the other side.
Summary of Contents for FEG605X
Page 1: ...FEG605X 600mm Stainless Steel Freestanding Range Gas Cooktop Electric Multi Function Oven...
Page 42: ...42...
Page 43: ...43...
Page 44: ...Cod 1102377 2...
