10
5/ DETERGENT PRODUCTS AND ADJUSTING THE WATER SOFTENER
Important:
It is very important to set the water softener correctly.
- If the setting is too low, there is the risk of chalky marks appearing.
- if the setting is too high, there is the risk of causing clouding of the glasses.
If you relocate, adjust the water softener setting as required.
• Traditional tablets
Non-multipurpose tablets should be placed in the external compartment (Fig 04) or, for optimum
performance, pull out the dispenser drawer and lay the tablet inside (Fig 05).
• Powders or liquids (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and to the maximum mark for dirty
crockery. If the crockery is very dirty and for programmes with a pre-wash we recommend that you
add 5g of detergent (a dessert spoonful) into your dishwasher’s tub in accordance with the pro-
grammes table.
Important:
Keep these products out of children’s reach and away from dampness.
Only use products specially designed for dishwashers.
Fig. 04
Fig. 05
Fig. 03
• FOR TRADITIONAL PRODUCTS
• Your machine must be specially adjusted to use traditional products.
• Proceed as follows to adjust the water softe-
ner on the control panel:
—
Access setting mode by holding down the “Set” button until
you hear a double audible signal (long beep). Then press
twice briefly to access the water softener setting.
— The water softener setting is displayed on the screen (for example
c3
)
.
— To adjust and alter the setting to suit the water hardness, keep on briefly pressing one of the
keys or the other. The screen shows you the setting
c0
,
c1
,
c2
etc...
— The setting is validated automatically after 10 seconds if the
“
Set
”
button is not pressed again.
— Pressing “Set” enables you to validate the setting and move on to the next parameter.
T
Te
es
stt s
sttrriip
p
H
Ha
arrd
dn
ne
es
ss
s
0-10°F
10-25°F
25-40°F
40-55°F
55-70°F
> 70°F
S
So
offtte
en
ne
err
s
se
ettttiin
ng
g
T
Trra
ad
diittiio
on
na
all
p
prro
od
du
uc
ctts
s
Nb. Factory setting :
c0
c0
cI
c2
c3
c4
c5
