Kleenmaid DW24 X, Instructions For Use And Warranty Details

Page: 13 / 22

• 13 •
INSTALLATION
Building the free-standing machine in
If you install the dishwasher built-in under an existing worktop, you must attach it with the front
bracket to a fixed worktop . If installing in this way, proceed as follows:
- Remove the worktop by unscrewing the 2 screws under the edge of the upper plate.
- Fit the dishwasher into its housing.
- Adjust the height of the feet if necessary (fig. 4).
- Use two screws to fasten the front bracket to the kitchen worktop, so as to make your dishwasher
fast.
For safety reasons Kleenmaid recommends that your dishwasher is not installed directly
below a cooktop. If installation is carried out in this manner your warranty may be void.
Voltage : 230-240 V – 50 Hz – Fuses : 10 A
Power : 2150-2300 W
Capacity : 12 place settings Water pressure : 3 psi/0.2MPa min
100 psi/0.7 MPa max
Water evacuation pipe height : 60 cm - 1 m
The dishwasher can only use cold water pipe.
TECHNICAL CHARACTERISTICS
NOTE :
These measurements are
shown without worktop fitted. If
installing with worktop fitted :
1 - To overall height add 32mm
2 - To overall width add 4mm
3 - Overall depth of worktop from
rear
to front corners = 581mm
4 - Overall depth of worktop from
rear
to centre front 600mm
Front bracket