3
♦
CHECK OF HEATING (WITH CYCLING)
Press
START
button, the left 2 digits indicate ‘07’
During heating the
NORMAL
LED is flashing. As soon as the board detects a rise by 5°c, the
heating stops and the
NORMAL
LED comes on solid.
If after 5 minutes heating has not risen 5°c the below fault code will be displayed in the right 3
digits.
‘d03’
Heating fault (Temperature rise less than 5°c
after 5 minutes)
♦
CHECK OF REGENERATION VALVE (WITHOUT CYCLING)
Press
START
button, the left 2 digits indicate ‘08’
NORMAL
and
INTENSIVE
LED’s come on alternately. Check the water drains from the
regeneration containers in the distributor.
♦
CHECK OF RINSING PRODUCT THRERMO-ACTIVATOR (WAX BLOCK) (WITHOUT
CYCLING)
Press
START
button, the left 2 digits indicate ‘09’.
AUTO WASH
and
QUICK
LED’s come on alternately. After a few moments check the release
of rinse aid on the inner door (wipe it off and close the door to continue test).
♦
CHECK OF DRAIN PUMP AND DRYING THERMO-ACTIVATOR (WAX BLOCK) NO. 2
Press
START
button, the left 2 digits indicate ‘10’.
There will be 10 seconds of cycling to wash away rinse aid.
QUICK
LED is flashing, followed
by supply to drain pump and thermo-activator No 2. Disassemble the vent cover on the inner
door and confirm vent is 100% open. The
QUICK
LED flashes during draining and comes on
solid as soon as the low level is attained. If low level is not attained within 30 seconds, the
below fault code will be displayed in the right 3 digits.
‘d02’
Draining fault (Draining duration until low
level greater than 30 seconds).
Note. Advance to next step (‘11’) is automatically performed, but it is impossible to advance if
the machine remains at high level.
♦
EXIT FROM TEST PROGRAM
The 2 left digits indicate ‘11’, At this stage, you can disconnect power and dishwasher will exit
test or you can press the
START
button again and the 2 left digits will indicate ‘12’. Press
START
button again and dishwasher will exit test program.
♦
DETECTION OF LEAK OR OVERFLOW
Detected throughout test program by the activation of contacts 21-23 on pressure switch or
float switch contacts. The fault code below is displayed over the right 3 digits.
‘d07’
Leak fault (Initiation of anti-leak device)
