• 6 •
IMPORTANT ! : KLEENMAID RECOMMENDS
THAT YOUR DISHWASHER BE INSTALLED BY AN
AUTHORISED KLEENMAID INSTALLER OR
SERVICE AGENT !!
Before you start :
1 . These instructions are intended as a guide
only. It is the responsibility of the Plumber
and Electrician to ensure that each
installation complies with local by-laws.
2 . Connection to cold water is recommended.
3 . When installing the Dishwasher, check that
the drain hose does not become restricted or
kinked.
Levelling : Adjusting the feet (Fig. 4) :
Make sure that the machine is properly upright
and stable. The four feet may be altered, adjust
them if necessary using a wrench or a
screwdriver. Badly adjusted feet may move the
door off centre and make the machine
unstable.
IMPORTANT : Do not connect the dishwasher to
the power or water supply before completing
installation.
If you are installing your dishwasher on carpet,
adjust the feet so that you leave space for air to
circulate underneath the machine.
Fitting your machine into your kitchen :
The building in sizes for the machine are given
in the “technical characteristics” chapter on
page 12.
Plumbing :
. Water Supply (Fig. 2)
a . The water supply to the Dishwasher should
not be less than 12 mm domestic water pipe.
A readily accessible tap must be installed in
the supply pipe.
b . The inlet connection hose supplied is fitted
to a 3/4" BSP male thread, which must have
an adequate sealing face for the washers
supplied.
c . The water supply pressure is to be between
21 kPa (4.0 psi) minimum and 970 kPa
(140 psi) maximum.
If pressure is greater 100 psi, it is recommended
to fit a pressure limiting valve to prevent
damage from rises and increased pressure of
peak demand.
INSTALLATION
