- 7 -
Use only water in the appliance! Do not put any other liquids or foods in the Water tank
(Reservoir).
TROUBLE SHOOTING
…………………………………….… ……
Problem
Solution
No coffee dispensed
Make sure the capsule is properly positioned, capsule slot not
obstructed, brewing chamber cover properly closed, water tank full
and properly placed. Perform the priming procedure by turning
Coffee/Steam selection knob to the off position, wait a few
seconds, and then turn it clockwise back to the Coffee position.
Repeat if necessary
, especially if the tank has been refilled
.
Coffee not hot enough
Preheat cup (hot water without capsule), descale if necessary.
No hot water/steam
Remove steam nozzle and clean, descale if necessary.
Milk does not froth
Check the Coffee/Steam selection knob position, and clean
the steam dispenser if necessary.
Start with cool or cold milk only.
Milk for cappuccino not
frothy enough
Dismantle the steam nozzle and clean all its parts. Use only cold,
whole milk.
Noisy pump
Make sure the water tank is full and properly placed.
Capsule area leaking
(water in capsule container)
Position capsule correctly.
If leakage persists, contact the retailer or supplier of the machine.
CLEANING AND MAINTENANCE
……………………… …….….
1. System Cleaning
To refresh the inside parts of the system, you can choose to repeat the procedure of coffee brewing
several times and meantime try to brush the inside brewing chamber capsule holder with a soft
brush between different times. Clean the casing, with a soft damp cloth. The water tank, drip tray
and used capsule collection container can be hand-washed in warm soapy water then rinsed
thoroughly. The coffee/beverage outlet can be removed for cleaning by rotating the vertical mark to
the left. It may be placed in a secure place in the upper basket of a dishwasher. The outlet is
re-installed by following the reverse procedure to removal.
Note: Before attempting to clean the appliance, remove the plug from the power outlet. Do not
immerse the machine or its power cable in water or other liquids. Allow the machine to cool before
starting the cleaning procedure.