D O O R H O L D E R U S E R G U I D E
4
Un-Enrol Unit
Remove the unit from it’s current location and press the
UN-ENROLL
button on the controller.
Press Un-Enrol Button and scroll
to unit no
Number on display
remains the same
Number on display decrements
Success
Failure
Try again
Figure 6: Un - Enrol Unit
Use the
enrol
and
system check
buttons to choose the unit number The flow chart above shows the process. Use this if you ever
want to take an enrolled door holder out of your system.
Mounting Door Holder
Remove the battery cover and batteries.
Fit the door holder to a wall or floor-mounting bracket behind the fire door, at least 500 mm from the axis of the hinge. To avoid
warping the door, we recommend fitting at a height close to that of the door closer but within easy reach of the release button when
the door is open. Using the template supplied, drill three mounting holes (and insert the masonry plugs supplied if required).
Screw the mounting lug on the fixing surface as shown below. Fit the door holder to it and slide to the side to lock in place. Fit the
remaining two screws through the battery compartment.
Using four screws supplied, fit the keeper to the back of the door to line up with the steel segments of the door holder. The door
holder will adjust through 30 degrees to help alignment.
The unit is secured to the wall using three screws.
Programming Controller
Fix this screw first
PLace unit on wall then fix these
two screws after. Access to screw
holes via battery compartment
92mm
18mm
24mm
42mm
