Antenna & Antenna Cable
•
Place the threaded SMA connector of the Antenna Cable through the hole in the mounting
bracket on its under-side as illustrated.
[Figure 1]
You should have roughly 5mm of thread
exposed on the top of the bracket.
•
Thread your antenna onto the SMA connector. The Antenna will screw down until it is
touching the bracket. This fitting should be firm enough not to move but not excessively
tight.
[Figure 2]
•
As a safety measure, please ensure your antenna cable is sitting snug against the body of
your drone where it cannot possibly be hit by the props. Also take note of the cable paths
illustrated in pictures.
[Figure 3]
•
Once the antenna cable is positioned correctly, and the Antenna has been tightened down
onto its bracket, connect the other end of your antenna cable to your PPP or PPK unit.
[Figure 4]
Figure 1:
Rev1
10
Summary of Contents for Phantom 4
