25
EN
COMMISSIONING AND OPERATION
First use
• Carefully remove the device from the packaging. Keep the date for later storage of
the device.
• Make sure that the power switch (21) is in the „0“ position before plugging in the
device.
• Make sure that the device is installed in accordance with the operating instructions.
• Do not use the same socket for several high-power electrical appliances to avoid
overloading the circuit.
Switch on
• As soon as the power plug of the device is plugged into the socket, the red/blue
power indicator (1) lights up.
• When you press the on/off button (20), a short beep is heard and the unit is
switched on.
• The following settings are displayed on the screen: The day display (18) shows the
current day of the week (the default setting is MON), the hour display (17) shows
the hours, the minute display (16) shows the minutes and the temperature display
(15) shows the current room temperature (the default degree display is °C). When
the automatic mode (A) is activated (alarm settings, preset automatic mode),
the default setting is 35 °C. If the unit suddenly switches off during use and then
switches on again, the last set operating mode is continued.
Setting the time and date
1. Press the OK (12) and SET (13) buttons simultaneously for five seconds when
switching on The day of the week indicator (18) flashes.
2. Press the Increase (10) and Decrease (11) buttons to select the date Confirm the
entered date by pressing the SET (13) button. The day of the week display (18)
stops flashing.
3. The hour display (17) now starts to flash. Press the Increase (10) or Decrease (11)
button to select the hour.
4. After pressing the SET button (13), the minute display (16) flashes on the screen and
the minutes can be set.
5. Save your settings by pressing the OK button (12) and exit the settings menu.
