Klarstein 10034093, Manual

Page: 20 / 56

20
EN
TROUBLESHOOTING
Problem Possible Solution
Pressing shaft get stuck. A Press“reverse” button for
5-10seconds ,then press “pause/
start” button to
work again
B Pull off the plug, Dismantle the
cavity and pressing shaft, clean out
the left residue from hopper and
feeding hole, then assemble
to restart again
.
Motor stop working
without oil coming out
A:it needs 30 seconds for machine to
be pre-heated. B，Check if hopper and
hopper lid set rightly.(hopper can be set
rightly only if cavity lock buckle on the
right position.)
motor working without oil coming out A cavity protection cover has not
rotated to the right position
Motor stops by accident. A: check if the hopper without material
over 1 minute, please press
“ pause/start” button to restart
again if in protection proceed.
B: It would be in protection proceed
if keep working over 45 minutes
C: Check if big size material in the
hopper got stuck over one minute,
it would be in protection proceed
with this case. please restart the
machine, mix material with Muddle.
D: Check if hopper or hopper
cover in the right position.
Hopper set at the wrong position A，Check if cavity lock buckle
in the right position.
Cavity lock buckle cannot
be set to right position
A，Set the pressing shaft in the
hexagon hole first then the cavity.
Light Codes
Guiding light reference Machine status
Quick flashing red light Pre-heating