22
EN
7
Lift up the fully assembled extraction hood and pull the exhaust duct out of
the ceiling (see Fig. 8). Fasten the angle irons to the suspension plate using six
M4x10 mm screws, M4 nuts and washers.
8
Loosen the inner chimney and fasten it to the suspension plate with three
ST4x8 mm screws.
Installing the Carbon Filter
Note:
An activated carbon filter is not included. But you can buy it as an extractor
hood.
Plug the activated carbon filter into the
unit and turn it in clockwise direction.
Repeat the same on the other side.
Make sure the filter is securely locked.
Otherwise, it would loosen and cause
dangerous. When activated carbon
filter attached, the suction power will
be lower.