21
EN
INSTALLATION
Step 1
Note
: Do not connect the appliance to the electrical supply at this time. The screws
and plugs supplied with this package are only suitable for SOLID wall installation. For
any walls other than solid, such as cavity, the appropriate fixings MUST be used.
1. Unpack the appliance, carefully lift the surround from the carton and stand upright.
2. Decide on the position where the suite will hang on the wall and determine a height
for the fire to be fixed. (1100mm to 1200mm from the floor to the top screw fixings
is a recommended height).
Step 2
Note
: Always ensure intended wall area to be drilled is free from hidden electrical
wires, water and/or gas pipes.
1. Drill the holes (Ø7 mm) in the wall according to Figure 1 and Figure 2.
2. Use two wall plugs and two 5x35 mm screws provided and screw the screws into
the 2 holes, leaving the end of the screws with 10mm protruding from the wall.
3. Offer the appliance up into position, the 2 keyhole slots (see Figure 2) at the back
of the suite will sit over the 2 screws protruding from the wall. Ensure the fire is level
fixed.
1
2
