12
Stage 2
• Drain the cleaning solution from the internal reservoir by removing the rear drain cap and plug.
• Add fresh water to the Max. permit water volume line.
• With the stand-by mode, keep pressing ON/OFF button at least 5 seconds to activate the self-clean mode
again which will now act as a rinse.
• Upon completion of this final stage of the self clean process, the unit automatically changes to stand-by
mode. Proceed to drain the water from the internal reservoir by removing the rear drain cap and plug. Leave
the lid on the ice maker open to allow it to air dry.
NOTE
: Please note if there is a water shortage during Self-cleaning mode, the unit will automatically go into
stand-by mode; If water bucket is fail to turn over, icon
will be on, you need to long press ON/OFF button
for more than 5 seconds to release self-cleaning mode to change for other operations.
Cleaning and stop use.
• Make sure to unplug the appliance before cleaning and long time off use.
• Use a damp cloth to clean both the interior and exterior of the appliance.
• Water tank cleaning.
• Unscrew the nut of water outlet, drain off the water.
• Pour clean water into the water tank, use a clean cloth to wipe water tank around. Pour clean water again
until the flowing out water is clean, and then drain off water and grip the nut.
• Do not use organic solvents, boiling water, cleaning agents, strong acids, strong acid and Alkali etc substan-
ces for cleaning.
• If ice machine will be off use for a long time, you should unplug the appliance, drain off the water and dry
the appliance with a clean cloth, store the ice maker in a clean place.
Troubleshooting
Faults
Reason
Treatment
WORK indicator is not
light.
Power Source is not
switched on.
Check the power supply matches
Check the power cord is connected correctly
Internal components are damaged. Maintenance in
professional department.
ICE FULL indicator
is light.
Ice fullness.
Remove the full Ice cube.
Low-temperature
protection
(temperature is lower
than 5°C).
Move the Ice maker to a warmer place, where the ambient
temperature is higher than 5°C.
Malfunction indicator
light flashes.
Ice making box reset
in bad condition.
Check whether any foreign body stuck the ice making box.
Internal components are damaged. Maintenance in
professional department.
