18
EN
USE AND OPERATION
Be sure freezer stays in upright position during moving it. Do not tilt it for more than
45°from up- right. Never upset it. Do not apply force on any external part such as
pipe, condenser, door and its handle for moving, freezer must be well packed and
secured in long distance transportation to avoid damage from impacting and or great
rocking.
Placement
The freezer should be placed on a flat and solid-top surface. It should be kept away
from sunlight, heat source, humid or mess place. The freezer should be kept away from
the wall for a proper space for good air circulation. When the freezer is placed in a
cupboard, the rear of the cupboard must be removed out for good circulation.
Power Supply
Before the freezer is plugged in, check the following: There must not be any damage
on all electrical wire. Earthing screw must be well fixed. Wall outlet must be properly
earthed. Be sure that everything is in normal condition and the freezer can be plugged
in.
Before first Use
• When operating is in normal condition and the freezer without any load until it
auto stops at the desired temperature, usually it takes 2 or 3 hours. Then set the
thermostat to the required setting and place foods in.
• Freezer‘s temperature can be adjusted by turning the knob of the thermostat. A
medium setting is the most suitable for general operation. The position „4“ is cooler
than the position „1“. Freezer‘s temperature will vary depending on the quantity
of foods stored and the frequency of the door opening, In order to maintain good
cooling efficiency and save energy, We recommend you not to store too much
foods and not to open the door too frequently.
Defrosting
• For the most efficient operation and minimum energy consumption, defrost the
freezer when the frost on the evaporator is excessive 3 to 4 mm thick. To start
defrosting, turn the temperature control to “OFF”, unplug the freezer, remove
the food and drawers. After the frost or ice has melted, discard the melted water
and dry up the interior of freezer. Then the freezer can be restarted by turning its
thermostat to the desired setting.
• Never use any sharp of metallic instruments (e.g. knives) to remove frost/ice from
the evaporator as this will damage the evaporator
