Power Supply Connection
1.
Nominal voltage/Frequncy:220~240V~/50Hz
；
2.
Standard socket with earth connection(12~16A,250V~)
3.
If the power cord is damaged, or the plug does not match the socket, and the socket is not
equipped with an earth connection, etc, you must have it checked or replaced by a
qualified electrician to prevent any risks.
Wine Cabinet Installation
1.
When you receive the cabinet, make sure when you unpack it there is no flaws in its
external appearance (from shocks, deformation, etc.)
2.
Open the door and check all interior fittings and supplied items if are all complete (shelves,
instruction, control panel, etc.) Please install it according to the following points if the
shelves or shelf brackets fall off during transit.
3.
Carry your wine cabinet to the final place to see if there is no problem with it after
checking. Observe the following when placed:
A) Ensure that there is a minimum of 5cm between your wine cabinet and the left & right
wall; leaving a space of at least 8cm between the back cabinet and the wall.
B) Position the wine cabinet on a flat level surface, if not, adjust the feet of wine cabinet to
keep level.
4.
Away from sources of heat and high humidity areas (laundry room and bathroom, etc).
5.
Do not tilt it at an angle of more than 45° when move the cabinet. Allow a minimum 10-
minute interval between transit and re-starting.
6.
Make sure the ventilation is free if you wish to install your cabinet into a worktable,
otherwise, it will reduce the effect of usage.
Temperature Setting
The temperature setting of wine cabinet
:
1.
The digital tube on the control panel indicates the temperature, the left digital tube
indicates the temperature and the temperature indicating range is 5
℃
~22
℃
（
40
℉
-
72
℉
）
,the right ones indicates the actual temperature of inner cabinet, and the range is
0~37
℃
(32
℉
-99
℉
)
2.
The temperature setting range of cabinet is 5
℃
~22
℃
(41
℉
-72
℉
)
3.
Customers can reset the temperature according to their actual demands. The wine cabinet
will turn on and the indicator will turn on until the desired temperature is achieved.
4.
Introduction of Display Plate Function
POWER
Controls the ON/OFF of the whole system.
℃
/
℉
This button switches from Fahrenheit to Celsius.
Light ON/OFF
Control the ON/OFF of LED light
▲
Press this key to adjust the incremental set of temperature
▼
Press this key to adjust the reduced set of temperature
RUN
LED light will illustrate when the compressor is operating.
SET CHAMBER
Digital display of preset temperature
CHAMBER
Digital display of inner cabinet temperature
