Applying Decals
Before applying boat registration decals (if required), clean the area with alcohol or any solvent that does not leave a residue. Make
sure solvent is put aside and is dry. Using a propane torch, lightly pass the flame back and forth over the area where the decals will
be applied.
Don’t try to heat the surface.
This process will enhance the adhesion of the decals.
BEFORE LEAVING SHORE & SAFETY PROCEDURES
• Check the weather conditions especially wave conditions in open water. Anticipate changing weather conditions and act accord-
ingly.
• Review the maximum capacities on the capacity plate. Ensure you are safely within these limits.
• Make sure all passengers are wearing Personal Flotation Devices.
• Take an extra paddle.
• Let someone know where you are going and when you will return.
CARE AND MAINTENANCE
With minimal care and maintenance, your boat has been designed to provide you with many years of enjoyment.
• Your canoe can be cleaned with warm water and any standard detergents. More difficult stains, such as brackish watermarks, may
be cleaned with a petroleum based cleaner. Read the manufacturers' instructions carefully before using any cleaner.
• Periodically check the integrity of all fasteners to ensure proper use.
• Polyethylene is a somewhat flexible material with some memory. This means it has a tendency to return to its original molded
shape if distorted. If this occurs follow these steps:
1. Relieve the pressure that caused the dent or distortion by supporting the boat differently or removing gear.
2. Place the boat in the warm sun. Usually the south side of a building is the warmest spot. As the boat warms up usually (but
not always) the boat will return to its original molded shape. This may take a few hours or a couple of weeks depending upon
outside temperatures and the degree of distortion.
STORAGE
• If possible, it is best to store your canoe inside for the winter otherwise store upside down. Do not store the canoe on sawhorses
right side up. If it’s stored upside down, position the supports about 1/3 of the way in from each end. Do not pile gear on top of
the canoe.