49
EN
Installation
Installation dimensions
Important Information
Installation
Fitted units
•
This appliance is only intended to be fully fitted in a
kitchen.
• This appliance is not designed to be used as a tabletop
appliance or inside a cupboard.
•
The fitted cabinet must not have a back wall behind the
appliance.
• A gap of at least 45mm must be maintained between
the wall and the base or back panel of the unit above.
•
The fitted cabinet must have a ventilation opening of
250 cm² on the front. To achieve this, cut back the base
panel or fit a ventilation grille.
• Ventilation slots and intakes must not be covered.
• The safe operation of this appliance can only be gua-
ranteed if it has been installed in accordance with these
installation instructions.
•
The fitter is liable for any damage resulting from incor
-
rect installation.
•
The unit into which the appliance is fitted must be heat-
resistant up to 90°C.
Note. There should be a gap above the oven.
!
• This appliance is NOT intended for use in a commercial
environment.
•
The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
• In case a new socket is needed, installation and cable
connection must only be done by a qualified electrician.
If the plug is no longer accessible following installation,
a pole disconnecting device must be present on the
installation site with a contact gap of at least 3 mm.
• Adapters, multiway strips and extension cords must not
be used. Overloading can result in fire.
•
If the appliance is not fitted with a supply cord and a
plug, the connection equipment must have a contact
separation in all poles that provide full disconnection,
and the appliance must be incorporated in the fixed
wiring in accordance with the wiring rules.
Summary of Contents for EBMS4503S
Page 2: ......
Page 27: ...Version 1 2 200629 EN User s manual for your built in microwave Model EBMS4503S...
Page 28: ......