35
35
EN
Mounting the hood
Open the glass panel and remove the aluminum grease filter. Mark the two holes
for the installation from the inside of the hood.
Take the hood back down again. Drill the two ø 8 mm holes at the marked
locations. Insert two wall plugs into the holes and two screws into the wall.
Hang the extractor hood back in the wall bracket and tighten the two screws on
the inside of the extractor hood.
Dowels
ST4-Screws
1
Before attaching the bracket to the wells, measure and opt for a level of attachment.
Please note: When the vent outside mode, the vent should be downward and inser
-
ted into the lower chimney. Make sure the vents are covered by the lower chimney.
Inner chimney
Outer chimney
Chimney bracket
2
Summary of Contents for BASE 604S/ED/WED
Page 21: ...DE...
Page 40: ...Version 1 3 180626 Thank you for buying this cooker hood...
