Fig.1
Trim cable to dimensions shown.
Slide crimp ferrule and shrink sleeve.
Braid wires and inner conductor.
Fig.2
a) Insert assembly into connector body and push the
crimp ferrule onto the cable braid wires.
b) Crimp shield layer by using crimping tools(0.311in.)
c) Solder the cable inner conductor into pin
Fig. 3
Heat shrink sleeve rear of connector and down onto
cable jacket using hot air gun.
SPECIFICATIONS
FREQUENCY RANGE
156MHz to 162MHz
GAIN AVERAGE
3 dB
IMPEDANCE
50 ohms
POLARIZATION
Vertical
ELEMENTS
Brass and copper
SWR at 156.8MHz
1.3:1
DC GROUND
Yes
RADOME
Polished polyurethane
CONNECTOR
FME pre-installed on RG8X coaxial cable
FERRULE
1"-14 chrome-plated brass
CABLE LENGTH / TYPE
20' / RG-8X
Performance specifications are nominal and unless otherwise indicated, are subject to change without notice.
WARRANTY / CONTACT
KJM warrants its products to be free of defects in materials and workmanship for 5-years. KJM's obligation
under this warranty is limited to repair or replace defective products. No material will be repaired or replaced
without written authorization from KJM. Repair or replacement will be made only after an examination
indicates defective material or workmanship at time of manufacture. KJM is in no event liable for
consequential damages, installation costs or other costs of any nature incurred as a result of the use of the
products manufactured by KJM, whether used in accordance with instructions or not. All shipping costs on
returned material are the responsibility of the purchaser. KJM is not liable for repair or replacement of any
product damaged by lightening, other natural phenomenon’s or incorrect installation including reverse polarity
connections. This warranty is in lieu of all others, either expressed or implied. Proof of purchase is required.
KJM Holdings –
– www.kjm-holdings.com
