5. Screw the chrome-plated brass ferrule on the
antenna base (A) and place it on the mount
(B)
(A)
(B)
6. Screw the mount on the antenna ferrule.
IMPORTANT: WHEN SCREWING THE
MOUNT, THE CABLE MUST NOT
TURN; TO DO THAT YOU MUST MOVE
THE CABLE EVERY TIME YOU GIVES
A RIDE TO THE MOUNT, this avoid the
cable damage
7.
Route the cable to the AIS device. If there is excess cable, it is
recommended to coil it in a gentle loop and secure
8.
Connect the FME to PL-259 connector and to the AIS receiver.
Note: It may be necessary to remove one FME connector to be able to fit through the cable guide hole on a
ratchet mount. If this is the case, solder the PL-259 connector supplied with the antenna using the instruction
below as guide:
