background image

7.  Locate the hook and loop 

fasteners closest to the centre 

of the underside of the canopy 

and wrap around poles to 

secure tightly. 

    
     Complete last part of leg pole 

assembly to erect frame.

8.  Position pad feet at the four corners. Unroll 

the webbing straps from the corners and 

connect them to the side release buckles on 

the corresponding 

corner. This stops 

the corners from 

‘splaying’ out when 

the steel poles are 

inserted. 

 

Note: Pad feet must 

angle toward centre 

of shelter with vertical 

slots facing outward. 

Webbing tape to be on 

outside of pad feet.

9.  Insert ends of poles 

into pad feet and 

twist until metal 

pin locks into slot. 

Repeat for other three 

pad feet locations. 

Adjust to form square 

webbing tape to be 

firm

10. Drive pegs through 

holes in pad feet 

to secure BEFORE 

proceeding to Step 

13.

 

Note: Two pegs are provided per pad foot. 

Additional pegs may be required, depending on 

soil type.

11. Attach hook end of canopy tension strap to square 

slot on the pad feet. Repeat for the remaining 

three pad feet. Pull down strap, at each corner to 

tighten.

12. Wrap web straps around pole at all four corners 

and close snap-in buckles. Pull strap to tighten.

14. Fine tune the canopy so it remains taut and 

positioned correctly over the frame.

15. If required, attach the optional solid wall to chosen 

side of the shelter.

REVERSE THE PROCEDURE TO LOWER THE SHELTER.

PACKING INSTRUCTIONS

Pack the poles and pegs into their bags. Fold the 

shelter from each side to the centre and in half again. 

Adjust to the length of the poles. Place the poles onto 

the floor and roll them inside so that the floor is on 

the outside. Store and pack the shelter in its bag.

Metal

pin in 

slot

Web Loop

Guy Rope

Peg

Completed Shelter

Angle faces

inward

Slots

13. Attach guy ropes to web loops located on outside 

seams of canopy then secure with pegs.

Reviews: