1. Slide four hexagonal head bolts into the channel found on
the back side of the shower tent (two on the top and two on
the bottom). Measure the distance required between each
bracket; this will vary depending on your roof rack.
Tip - Evenly space the L-Brackets for maximum support.
Ensure the shower tent is set to a height that is clear of
car doors.
2. With the desired distance between the L-brackets found,
fit the L-bracket in place. Add the M6 self-locking nuts
and loosely tighten. Repeat with the second L-bracket.
3. Slide two (or four) T-bolts into each roof rack. Orientate
the T-bolt base for the best fit.
4. Carefully lift the shower tent into position. Line up the
T-bolts to the L-brackets. Once aligned, add the washers
and nuts and fully tighten.
Tip - It is recommended to take a short drive after attaching
fixtures. Check on return to see if any further tightening of
brackets is necessary. Check fixtures regularly during use.
ATTACHMENT INSTRUCTIONS
3
Your Tuatara Shower Tent includes:
1 x shower tent with travel cover
2 x heavy-duty L-brackets
4 x T-bolt sets (M8 bolts, self-locking nuts and washers)
8 x M6 bolts (hexagon head)
8 x M6 self-locking nuts
2 x guy ropes
6 x pegs (4 x 5mm, 2 x 7mm)
1 x shower hook
1 x 10mm ratchet spanner
2
3
1
PITCHING INSTRUCTIONS
1. Unzip the travel cover and fold it out of the way. Release
the compression straps and carefully unroll.
2. Pull out the top arm until the hinge clicks into place.
Repeat with the second arm.
3. Adjust the height by tightening the webbing straps
located on the top corners of the tent body.
4. Peg out all four corners with the 5mm pegs. Peg out
the two guy ropes with the 7mm pegs and tighten the
tri-tensioners to ensure the shower tent remains securely
anchored.
5. Feed the shower hook into the vertical hole at the top of
the frame. Attach your shower bladder or showerhead
(up to 20 kg weight limit).
Tip - Insert pegs at a 45º angle to ensure the pegs won’t
pull out.
1. Carefully remove pegs, roll up the guy ropes, remove excess soil from the pegs and
store them in their bag.
2. Release the webbing straps.
3. To collapse the shower, release the hinge lever. First, fold in the bottom arm and then
the top arm.
4. Tightly roll up the shower tent (with peg bag secured inside) and secure the
compression straps.
5. Fold back the travel cover and zip to close.
COLLAPSING INSTRUCTIONS
5
2
4
1
INSTALLATION INSTRUCTIONS
