Attach ‘D-E-F-G’ vertical rods onto top of vertical rods ‘B-C-D’ already erected. ‘D’ should match ‘D’. Slip in silver ball bearings to snap into hole
and click. Add arcs ‘E’ on the second platform in the same way you did on the first, but this time at the ‘E’ position. **IMPORTANT** make sure
the opening on the canvas platform for the cat access hole is not over the lower access hole. The access openings from level to level should be
staggered. Repeat the same process with the top platform with the smallest arcs ‘F’ and canvas platform. REMEMBER to stagger access cut outs
from level to level.
Repeat same process with the top tier using ‘F’ arcs. ‘F’ should match ‘F’. REMEMBER to stagger access holes from level to level. Place top hub
over ‘G’ on top of each vertical support rod and slide into place until ball bearings snap and click. ‘G’ should match ‘G’.
Slide netted cover over the top of
the unit. Doors should not cover
vertical support rods. Zipper
should run along vertical support
rods ‘C-B’.
When netting is over entire
Teepee, tighten with the two
drawstrings on bottom to keep
pets from escaping. Bottom
of unit should look like this.
Periodically check drawstrings
under unit to keep netting as
taught as possible.
Wrap canvas top wrap around hub at top of Teepee and secure. Add feathers.
3
F
E
F
E
G
G
G
G
G
G
F
Fig. 2
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
