Users Manual
1
Slab roller RM 1/RM 2
Packing and Transport
For the transport on a pallet the
Kittec
slab roller is wrapped with a cover foil.
Please check the slab roller instantly after receipt of the forwarder on damages.
Installation
Remove the packing, lift up the roller table laterally that you can put in on after another pair
of legs into the table. Secure the stand with the M5 screws on the four push in corners. Stick
the hand wheel flushing to the groove on the axle of the roller drive. Secure the hand wheel
against twisting or gliding out with the M6 screws on the axle. Fix the linen cloths laterally in
the clip board.
The working process
Unlock the roller drive on the left side by turning out the red wing screw until it is freely
movable. To roll the clay put it for protection of the slab roller between the linen cloths. Adjust
the height with the hand wheel. Turn and rotate the clay between the steps. Tip: You can
protect the cloths with foil.
