2
Install the tow panel at the rear of the :Move mini using two
M3x10mm countersunk screws, passing through the hole in the
base and threading into the connector below. Thread an M2x16mm
screw halfway through the small hole. This will be the tow-bar to
connect the trailer.
3
NOTE:
There will
be a small amount
of movement of
this part.
To begin building the trailer, use two M2x16mm
screws to assemble the exterior sides of the
trailer: thread the M2 nuts partially onto the
ends by approximately 3mm.
Use an M2X6mm bolt to attach the wheel
to the outside. Thread the screw into the
perspex, making sure the wheel is loose
enough to allow the wheel to spin freely.
4
5
Use one of the M3x6mm screws
to attach the tipper bucket side
panel. A washer should be inserted
between the panels. Thread the
screw into the perspex, making
sure to leave this loose enough to
rotate freely.
