5
A
A. Exhaust port
IMPORTANT:
If blower motor is not positioned with flat sides
facing the back of the microwave oven (as shown), performance
will be poor.
6.
Reattach blower motor to back of microwave oven with 2
screws removed in Step 3 of “Wall Venting Installation Only.”
Securely tighten screws.
NOTE:
If blower motor is not correctly oriented, the 2 screws
removed in Step 3 cannot be reattached to the microwave oven.
7.
Reattach damper plate. Make sure damper plate tabs are
inserted into the slots in the top of the microwave oven.
A
B
C
D
A. Damper plate
B. Screws
C. Damper plate tabs
D. Slots
8.
Secure damper plate with 2 screws removed in Step 1 of
“Wall Venting Installation Only.”
5.
Rotate blower motor so that exhaust ports face the top
of microwave oven, and flat sides of blower motor face
back of microwave oven. Lower blower motor back into
microwave oven.
Locate Wall Stud(s)
NOTE:
If no wall studs exist within the cabinet opening, do not
install the microwave oven.
See illustrations in “Possible Wall Stud Configurations.”
1.
Using a stud finder, locate the edges of the wall stud(s) within
the opening.
2.
Mark the center of each stud, and draw a plumb line down
each stud center. See illustrations in “Possible Wall Stud
Configurations.”
Possible Wall Stud Configurations
These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at End Holes
Figure 1
No Wall Studs at End Holes
Figure 2
A
A
B
C
D
E
E
F
A
A
B
C
C
D
E
E
F
NOTE:
If wall stud is within 6" (15.2 cm) of the vertical centerline
(see “Mark Rear Wall” section), only recirculation or roof venting
installation can be done.
Wall Stud at End Hole
Figure 3
Wall Studs at End Holes
Figure 4
A,D
B
E
A,D
C
E
C
F
A
A,D
B
C
C
D
E
E
F
A. End holes (on mounting plate)
B. Cabinet opening vertical centerline
C. Wall stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers