5
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Parts Supplied
Remove parts packages from dryer drum. Check that all parts are
included.
Remove Decorative Mat
Remove the optional decorative mat (included) from the top of
the dryer and set aside.
Attach Door Handle
1. Insert the 2 screws through the holes in the door.
2. Place the plastic washers onto the screws.
3. Attach the handle by hand tightening the screws, first the top
then the bottom.
4. Push the handle against the door. Using a Phillips
screwdriver, tighten the screws.
NOTE: Do not overtighten.
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read “Electrical
Requirements,” “Gas Supply Requirements” and “Venting
Requirements” before purchasing parts.
■
For close-clearance installations between 33" (83.8 cm) and
38" (96.5 cm), see “Plan Vent System” section for venting
requirements.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the “Assistance
or Service” section of this manual.
■
Mobile Home Installation Kit. Ask for Part Number 346764.
■
Metal exhaust system hardware.
Options
Pedestal
Are you placing the dryer on a pedestal? You may purchase a
pedestal separately for this dryer. This pedestal will add about
11" (27.9 cm) to the height of your dryer for a total height of
approximately 53" (134.6 cm).
For a garage installation, you will need to place the pedestal at
least 7" (17.8 cm) above the floor.
Optional pedestal
To order, call the dealer from whom you purchased your dryer or
refer to the “Assistance or Service” section of this manual. Ask
for Part Number LAV2701RSS.
Door Reversal Kit
Would you like to change your dryer door swing from a right-side
opening to a left-side opening? To do so, you will need to
purchase a Door Reversal Kit.
To order, call the dealer from whom you purchased your dryer or
refer to the “Assistance or Service” section of this manual. Ask
for Part Number 8182652.
■
Flat-blade screwdriver
■
#3 Phillips screwdriver
■
8" or 10" pipe wrench
■
8" or 10" adjustable
wrench (for gas
connections)
■
⁹⁄₁₆
" (14 mm) open-end
wrench (for adjusting dryer
feet)
■
Level
■
Vent clamps
■
Caulking gun and
compound (for installing
new exhaust vent)
■
Tin snips (new vent
installations)
■
¹⁄₄
" nut driver or socket
wrench (recommended)
■
Pipe-joint compound
resistant to LP gas
■
Pliers
■
Tape measure
A. Door handle
B. Plastic washers (2)
C. Screws (2)
A
C
B
38"
(96.5 cm)
